Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 50-3/8″ (1280 mm) x
19-5/8″ (498 mm)
Basin area, top 57-5/16″ (1456 mm) x
24-1/16″ (611 mm)
Weight 106 lbs (48.1 kg)
To overflow:
Water depth 15-5/16″ (389 mm)
Capacity 66 gal (248.3 L)
* Approximate measurements for comparison only.
Drop-in cutout 64-1/2″ (1638 mm) x 30-1/2″ (775 mm)
Blower
motor:
Heater V Hz A
300 W 120 60 10
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Locate the outlet behind the bath and within 24″
(610 mm) of the blower motor.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 47 lbs/square foot (227 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
This product is designed for a drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
1-1/2"
Bath Drain
66" (1676 mm) 32" (813 mm)
3/4" (19 mm)
2-1/2"
(64 mm)
11-1/4"
(286 mm)
16"
(406 mm)
4-1/8"
(105 mm)
1-1/2"
(38 mm)
Drop-in Rim
Detail
1-1/4"
(32 mm)
No change in measurements if connected
with drain illustrated. (K-7271 or K-7272)
Blower Motor Access
20" (508 mm) W x 15" (381 mm) H
Lumbar Angle 24˚
19"
(483 mm)
Product Diagram
ARCHER
®
ARCHER
®
5.5’ BUBBLEMASSAGETM BATH
Page2of2
1208016-4-
A