Installation Guide

8. Complete the Finished Walls
Cover the framing with water-resistant material.
Provide suitable access to the control amplifier.
Tape and mud the wall and deck materials. Install the finished wall and deck materials. Seal the
joints between the bath rim and the finished deck material with silicone sealant.
Drill a 5/8″ (16 mm) hole through the wall material exactly where the user interface will be
installed. Refer to the ″Roughing-in - Required Components″ section to determine the user interface
installation location.
Route the user interface cable through the hole in the wall material, and tape or otherwise secure
the cable so it will not fall between the walls.
Install the faucet trim according to the faucet trim manufacturer’s instructions.
Water-Resistant
Deck Material
5/8" (16 mm) User
Interface Hole
Finished Material
Apply silicone
sealant.
Silicone Sealant
24"
(610 mm)
10"
(254 mm)
Kohler Co. 13 1181167-2-E