Specification

Technical Information
Fixture*:
Bathing well
Basin area, bottom 50-3/8″ (1280 mm) x
19-5/8″ (498 mm)
Basin area, top 57-5/16″ (1456 mm) x
24-1/16″ (611 mm)
Weight 69 lbs (31.3 kg)
To overflow
Water depth 15-5/16″ (389 mm)
Capacity 66 gal (248.3 L)
* Approximate measurements for comparison only.
Drop-in cutout 64-1/2″ (1638 mm) x 30-1/2″ (775 mm)
Amplifier/control: 15 W (per
channel)
120 V 50/60 Hz
Required Electrical Service
Circuit protected with a Class A Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device
(RCD) required: 120 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide. Ensure
that the interface, amplifier, and transducers are functional
before completing the installation.
Control amplifier fits 16″ (406 mm) center studs. 25’ (7.6 m)
cables are included.
Locate the bath within 24″ (610 mm) of a GFCI-protected 120
V, 15 A grounded electrical outlet.
Floor support under this product must provide for a minimum
of 44 lbs/square foot (215 kg/square meter) loading.
This product is designed for drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
Will comply with ADA when installed per Section 607
Bathtubs of the 2010 ADA Standards for Accessible Design.
32" (813 mm)
1-1/2"
(38 mm)
Drop-in Rim
Detail
17-1/2"
(445 mm)
No change in measurements if connected
with drain illustrated. (K-7272)
Lumbar Angle 24˚
4-1/8"
(105 mm)
16"
(406 mm)
11-1/4"
(286 mm)
2-1/2"
(64 mm)
3/4" (19 mm)
66" (1676 mm)
1-1/2"
Bath Drain
19"
(483 mm)
*Recommended User
Interface Location
5-5/8"
(143 mm)
3-1/2"
(89 mm)
7/8"
(22 mm)
14-1/2"
(368 mm)
11-3/4"
(298 mm)
3-3/16"
(81 mm)
User Interface
Control Amplifier
1-1/2"
(38 mm)
*24"
(610 mm)
*10"
(254 mm)
Product Diagram
ARCHER
®
ARCHER
®
5.5’ VIBRACOUSTIC
®
DROP-IN BATH
Page2of2
1214514-4-
A