Installation Guide

1. Prepare the Rim-Mount Faucet (Optional)
NOTICE: Before installing a rim-mount bath faucet, refer to the specification sheet on the bath product
page at www.kohler.com for faucet area dimensions for your model.
NOTICE: To accommodate the bath shroud, use flexible connections to attach the water supplies to a
rim-mount faucet.
NOTICE: For rim-mount faucet installations, route the water supply lines high enough to permit access
for making the final connections from above the shroud.
Refer to the specification sheet on the bath product page to determine the recommended faucet area
and drain model for your bath.
Refer to the installation instructions packed with the faucet to determine faucet hole size.
Locate the faucet in the desired location on the bath rim. Make sure the faucet will not interfere
with the drain and overflow. Make sure the faucet trim fits on the bath deck without overhanging.
Use a pencil to mark the faucet centerlines for drilling.
Refer to the valve installation instructions for the correct valve hole size.
Carefully drill the faucet holes.
IMPORTANT! Do not install plywood or other faucet reinforcement under the rim of this bath. Any such
reinforcement may prevent the bath from properly seating into the shroud.
Install the valve according to the installation instructions included with the valve. Do not install the
faucet trim until instructed to.
Bath
Rim
Recommended Faucet Area
(See Specification Sheet
for Dimensions)
Kohler Co. 5 1237791-2-G