Rough-In Guide

Product Information
Applicable product:
Cube VibrAcoustic bath K-1969-VB
Cube VibrAcoustic bath with
chromatherapy
K-1969-VBC
Fixture*:
Bathing well:
Basin area, bottom 39-3/8″ (1000 mm) x 39-3/8″
(1000 mm)
Basin area, top 44-5/8″ (1134 mm) x 44-5/8″
(1134 mm)
Weight 115 lbs (52.2 kg)
To overflow:
Water depth 27-1/2″ (699 mm)
Capacity 171 gal (647.3 L)
* Approximate measurements for comparison only.
Drop-in cut-out 47″ (1194 mm) x 47″ (1194 mm)
Amplifier/
control:
Power per channel (rms) W V Hz
15 120 50/60
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Amplifier/control: 120 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
The bath is intended for under-mount/drop-in installation.
Control amplifier fits 16″ (406 mm) center studs.
A grounded outlet within the wall framing must be within 24″
(610 mm) of the planned control amplifier.
Cables are included, 25’ (7.6 m) each.
Four access panels are required for servicing the bath.
Floor support under bath must provide for a minimum of 97.9
lbs/square foot (478.2 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
34"
(864 mm)
48" (1219 mm)
1" (25 mm)
1-5/8"
(41 mm)
1-1/2" OD
3-1/2"
(89 mm)
No change in measurements if connected
with drain illustrated. (K-8150)
24"
(610 mm)
1-1/8"
(28 mm)
48"
(1219 mm)
24"
(610 mm)
3-7/8"
(99 mm)
*10"
(254 mm)
*24"
(610 mm)
Access Panels
30" (762 mm) L x 15" (381 mm) H Min
Access Panels
30" (762 mm) L x
15" (381 mm) H Min
*Recommended User
Interface Location
5-5/8"
(143 mm)
3-1/2"
(89 mm)
7/8"
(22 mm)
User Interface
Control Amplifier
14-1/2"
(368 mm)
11-3/4"
(298 mm)
3-3/16"
(81 mm)
Roughing-In
K-1969-VB, K-1969-VBC
UNDERSCORE
®
CUBE VIBRACOUSTIC BATH
UNDERSCORE
®
CUBE VIBRACOUSTIC BATH
1188028-1-
A