Instructions / Assembly

4 51383737-2-B 1383737-2-BKohler Co.Kohler Co.
Assembly
No tools necessary. Wash hands before assembly.
1. Place the stand on a flat, dry, cool, surface. Avoid sunlit areas, which will
encourage the growth of algae.
CAUTION: Risk of product damage. Do not use tools or overtighten the nut.
2. Assemble the spigot, two washers, and nut to the lower container as shown.
Handtighten the nut.
NOTICE: Verify that the filter is firmly secure by handtightening the nut located in
the bottom of the upper container.
3. Place the lower container on the stand. Place the upper container on the
lower container.
4. Place the lid on the upper container.
First Use
1. Pre-soak the filter by submerging it completely in warm (not hot) water for at
least 30 minutes to purge air from the filter. This will allow for faster flow rates.
Clean the plastic parts. Refer to the “Clean the Plastic Parts” section.
CAUTION: Risk of product damage. Do not use boiling water.
2. Remove the lid and fill the upper container with water.
3. Replace the lid.
CAUTION: Risk of product damage. Do not use tools or overtighten the nut.
4. If leaking occurs from the spigot, use clean hands to tighten the nut. Do not
use tools.
NOTICE: A dry filter cartridge will work slower until it has soaked for one day.
Nut
Washers
Upper
Container
(Treatment Tank)
Lower Container
(Safe Storage)
3.2 gallons
(12 liters)
2.9 gallons
(11 liters)