Installation Guide

111443-2-AA (B)
2 Kohler Co., Kohler, WI
TOOLS REQUIRED
 Level
 Drill with assorted bits
 Socket wrench with 8” extension
and assorted sockets
 Tape measure
 Framing square
MATERIALS REQUIRED
 1/4” lag bolts and washers (6)
 Wood screw and washer (1)
 Thin cardboard (provided)
INSTALLATION
 Rough-in the supplies and
drain piping and trap.
NOTE: The supply stop handles
cannot extend more than 3-3/4” from
the finished wall when in the open
position.
 Install sufficient backing behind
the finished wall to provide a
secure material for the
anchoring devices.
 Install hanger to wall according
to roughing-in dimensions.
Lag
Bolts
Hanger
NOTE: To avoid damage to
pedestal or floor, slide cardboard
under pedestal before moving.
 Mark the centerline on the floor.
 Position the pedestal on the
floor centerline so the mounting
hole is approximately 6-1/2”
from the finished wall.
 Position the lavatory on the
hanger and pedestal.
 Move the pedestal as required
to ensure proper fit in the
desired location.
NOTE: The lavatory must be
supported by the hanger and
pedestal.
 Check the lavatory placement.
 Mark the center of each
anchoring hole on the wall, and
mark the floor through the hole
in the pedestal bottom.
 Carefully remove the lavatory
from the pedestal. Then move
the pedestal from the area.
Mark Floor
Here
Pedestal
Finished
Wall
Anchoring
Holes