Installation Guide

Install the Lavatory (cont.)
Install the bracket to the wall at the marked location using lag bolts (not
provided).
Drill 1/4” mounting holes for the basin and pedestal at the marked locations on
the finished wall and the floor.
NOTE: You may also use other fastening devices of sufficient size and strength.
Move the pedestal over the drilled hole in the floor, and secure the pedestal to the
floor by carefully tightening the lag screw and washer.
Carefully set the lavatory basin on the pedestal so the basin is supported by the
bracket and the pedestal.
Verify the basin is positioned as desired.
Secure the basin to the wall with lag bolts and washers (not provided). Do not
overtighten.
If not already installed, install the faucet and drain to the lavatory according to
the manufacturer’s instructions.
Connect and tighten the trap to the drain, and complete the water supply
connections to the faucet according to the instructions packed with the faucet.
Run water into the lavatory and check all connections for leaks.
Installation du lavabo
ATTENTION: Risque d’endommagement du produit. Ne pas trop serrer les
connexions. Trop serrer pourrait casser ou fendre le lavabo ou la colonne.
Fixer le support au mur à l’emplacement marqué avec les tire-fonds appropriés
(non fournis).
Percer des trous de montage d’1/4 po pour le lavabo et la colonne aux
emplacements marqués sur le mur fini et le sol.
REMARQUE: Il est aussi possible d’utiliser d’autres systèmes de fixation de
dimension et de résistance suffisantes.
Placer la colonne sur l’orifice percé sur le plancher, puis sécuriser la colonne au sol
en serrant avec soin le tire-fond et la rondelle.
Placer avec précaution le lavabo sur la colonne de sorte qu’il soit soutenu par le
support et la colonne.
Vérifier que le lavabo est positionné tel que désiré.
Sécuriser le lavabo au mur à l’aide de tire-fonds et de rondelles (non fournies). Ne
pas serrer de façon excessive.
Assembler le robinet et le drain du lavabo conformément aux instructions du
fabricant.
Connecter et serrer le siphon au drain, puis terminer les connexions d’arrivée
d’eau au robinet selon les instructions emballées avec le robinet.
Laisser couler l’eau dans le lavabo et vérifier toutes les connexions pour voir s’il y
a des fuites.
Instale el lavabo
PRECAUCIÓN: Riesgo de daños al producto. No apriete demasiado las
conexiones. Si aprieta demasiado puede romper o despostillar el lavabo o el
pedestal.
Kohler Co. 9 1087257-2-A