Installation Guide

Installation Guide SKU#22653
USA/Canada: 1-800-4 KOHLER 1391085_2
www.kohler.com
Approved fastener
(Wire nut)
Electrical tape
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
5. Your product may appear different than the one illustrated. The installation procedures remain the same.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a clean and soft
cloth to protect finish. Confirm all parts are included.
2. To adjust length of cord, loosen the set screw (I) on the canopy (D) until the cord can
slide. Be careful not to remove the set screw. Adjust length of cord to set fixture at
desired height. Then tighten set screws (I); be careful not to pierce wiring.
3. Slide safety clip (J) down cord to touch canopy. Do not damage the cord insulation
layer.
4. Cut excess cord to minimum 6” beyond canopy (D).
a) Trim cloth 2” from the end.
b) Strip insulation 5/8” from end without cutting copper wire.
c) Twist each copper wire individually.
5. Attach mounting plate (B) onto outlet box with screws (C). Ensure the direction of
ground screw (L) and mounting screws (K) are as shown.
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten fixture green
or bare ground wire to the green or bare copper wire in outlet box with wire nut (A)
or fasten onto ground screw (L) on mounting plate. Fasten fixture white wire to the
white wire in outlet box with wire nut (A). Wrap the wire connector with electrical
tape so that the tape seals the end of wire nut (A), see diagram.
7. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten the fixture
black wire to the black wire in outlet box with wire nut (A). Wrap the wire connector
with electrical tape so that the tape seals the end of wire nut (A), see diagram.
8. Tuck wires carefully inside outlet box. Push the canopy (D) onto mounting plate
(B) letting screws (K) protrude through the holes in canopy (D). Secure the canopy
(D) to mounting plate (B) with nuts (E).
9. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated Max 40 W, Type B.
10. Install the small (F) and medium-sized glasses (G) onto glass holder, with screws (H).
11. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
Phillips &
Flathead
Screwdriver
Slip Joint
Pliers
Small
Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current
Tester
Electrical
Tape
Allen Wrench