Installation Guide

3
Kohler Co., Kohler, WI U.S.A.
1007275-2-
A
 Drill a 1/4” mounting hole at the
mark on the floor, then drill two 1/4”
hanger bolt holes at the marks on
the wall.
 Mount hanger bolts to the wall so
approximately 1-1/4” (3.2cm) of
each bolt remains exposed.
NOTE: Other fastening devices of
sufficient size and strength may also be
used.
Finish Wall
Hanger
Bolts
 Install the faucet and drain to the
lavatory according to the
manufacturer’s instructions.
NOTE: Do not fully tighten slip-joint
drain connections at this time.
 Position the pedestal mounting hole
over the hole in the floor.
 Secure the pedestal to the floor with
the wood screw and washer. Tighten
the wood screw until it is snug.
CAUTION: Risk of product
damage. Do not overtighten.
Overtightening may cause damage to
the product.
Pedestal
Wood Screw
Washer