Installation Guide

1007275-2-A
2 Kohler Co., Kohler, WI U.S.A.
TOOLS AND MATERIALS
REQUIRED
 Level
 Drill with assorted bits
 9/16” wrench
 Tape measure
 Framing square
 Channel lock pliers
INSTALLATION
 Rough-in the supplies and the drain
piping.
NOTE: The supply stop handles cannot
extend more than 3” (7.6cm) from the
finish wall when in the open position.
 Install sufficient backing behind the
finish wall to provide a secure
material for the anchoring devices.
 Apply two self-adhesive gaskets
(provided) to each of the three
ridges in the bottom recess of the
lavatory.
Gaskets
Ridge
BOTTOM VIEW
OF LAVATORY
Gaskets
Gaskets
Ridge
 Mark the centerline on the floor.
 Position the pedestal on the floor
centerline.
 Carefully set the lavatory on the
pedestal.
 Move the pedestal as required to
ensure proper fit in the desired
location.
 Level the lavatory. Add more
self-adhesive gaskets as needed to
level the lavatory.
NOTE: The lavatory must be
supported by the pedestal.
 Check the lavatory placement.
 Mark the center of each anchoring
hole on the wall, and mark the floor
through the hole in the pedestal
bottom.
 Carefully remove the lavatory from
the pedestal. Then move the
pedestal from the area.
Mark Floor
Here
Pedestal
Center of
Anchoring
Holes
Finish
Wall