Installation Guide

Tools and Materials
Before You Begin
CAUTION: Risk of personal injury. Handle with care.
Product can break, chip, or cause injury if handled carelessly.
Observe all local plumbing and building codes.
Do not rest or store the sink on the drain surface.
Prior to installation, unpack the new sink and inspect it for
damage. Return the sink to its protective carton until you are
ready to install it.
Inspect the existing drain and supply tubing. Replace if necessary.
Do not substitute another sealant if one is supplied with this sink.
Use the template supplied with the sink.
For replacement installations, make sure the existing cutout is the
same size or smaller than needed for the new sink.
Refer to the roughing-in information to ensure proper installation
for ADA applications.
Use these instructions for drop-in, above-counter, and vessel
installations. Follow only the instructions that apply to your
installation.
For wall-mount bracket installation: install the sink according to
the instructions packed with the bracket.
Choose between a wall-mount or countertop faucet. Either will
work, although a wall-mount faucet is recommended.
For installations using the supplied adhesive seal, install this sink
when the temperature is between 70°F (21°C) and 100°F (38°C).
Plus:
• 1/2" Drill Bit
• Hole Saw
• Safety Shoes
Scissors
Silicone
Sealant
Adjustable
Wrench
Safety
Glasses
Tape
Measure
PencilDrill
Jigsaw
1018897-2-B 2 Kohler Co.