Installation Guide

1. Preparation
Install the water supplies and drain piping according to the
roughing-in information.
Drop-In Installations
Determine the faucet centerline location. Consider the faucet and
handle escutcheon diameters, the length of the spout, and the
clearance between the spout and the sink rim.
Calculate the faucet centerline measurement: divide the
escutcheon diameter by two, then add 1/4″ (6 mm) to the result.
If necessary, round the calculation up to the nearest 1/16″ (2
mm).
Carefully draw the calculated faucet centerline on the cut-out
template. Choose the most suitable location based upon the
following factors:
•
compliance with all local plumbing codes
2" (51 mm)
Min.
Vessel
Cut-Out
1/4" (6 mm)
Min.
Cut-Out
Template
Countertop
Above-Counter
Cut-Out
Self-Rimming
Cut-Out
Faucet Centerline
Divide the escutcheon
diameter in half,
then add 1/4" (6 mm).
2" (51 mm) Min.
1" (25 mm)
Min.
Clearance
Kohler Co. 3 1018897-2-B