Installation Guide

Tools and Materials
Before You Begin
NOTICE: Adequate floor support must be provided. Note the model number on the components end of
the bath, then visit the product page at www.kohler.com for additional information.
NOTICE: Do not support the load weight of the bath by the rim.
NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support
of the bath. To avoid damage to the bath, lift by the rim at the sides of the bath.
NOTICE: Before installing a rim-mount bath faucet, refer to the specification sheet on the product page at
www.kohler.com.
NOTICE: For remote blower installations, refer to the installation instructions included with the remote
blower installation kit K-1446 before proceeding.
NOTICE: For -G2M Music Models: Refer to the installation instructions included with the amplifier for
wiring and installation details. Position the amplifier anywhere within the shroud or in a remote location.
If installed within the shroud, the amplifier will need to remain plugged into the electrical outlet at all
times.
NOTICE: For -G2M Music Models: This installation requires installation of an electrical outlet within 24
(610 mm) of the amplifier location. Refer to the amplifier installation instructions.
Observe all local plumbing and building codes.
Unpack and inspect the bath and components for damage. Return the bath and components to the
carton until installation.
To simplify future maintenance, make sure all plumbing and control board connections around the
bath are easily accessible.
Use conduit to route electrical wires from the circuit breaker.
Carefully plan moving the bath into the installation area. This bath will not easily fit through
doorways.
Two people are needed to install this product.
Install the bath to an adequately supported, level finished floor.
This bath is designed for freestanding installation only.
Safety Glasses PencilTape Measure
Silicone Sealant Level
Plus:
• Drop Cloth
• Shims
• Short Ø 1-1/2" PVC Pipe or Coupling
• 2x4
• Wood Blocks
Silicone Adhesive
Kohler Co. 3 1237791-2-D