Specification Sheet

29-1/4" (743 mm)
Notes
Required Electrical Service
Measure your actual product for rough-in details.
Two dedicated circuits required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzBlower:
120 V, 15 A, 60 HzHeater:
Technical Information
Provide one grounded electrical outlet within 24"
(610 mm) of each component.
All product dimensions are nominal.
FreestandingInstallation:
This bath is designed for freestanding installation
only.
EndDrain location:
45-1/8" x 19-11/16" (1146 mm x 500 mm)Basin area, bottom:
If installing a rim-mount faucet, make sure there
is no interference above or below the deck before
drilling any holes.
52-3/4" x 25-5/16" (1340 mm x 643 mm)Basin area, top:
105 lbs (47.6 kg)Weight:
43.8 lbs/ft² (213.9 kg/m²)Minimum floor load:
58 gal (219.6 L)Water capacity:
Footprint, 1265460, not required, not
included
Template:
Blower: 120 V, 10 A, 60 Hz
Heater: 120 V, 5 A, 60 Hz
Electrical component
rating:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-30-2019 03:43 - US
Archer
®
freestanding Heated BubbleMassage
™
air bath
K-2593-GH