Specification

No change in measurements if connected
Notes
Required Electrical Service
Measure your actual product for roughing-in
details.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device
(RCD).
Install this product in accordance with the
installation instructions.
120 V, 15 A, 60 Hz, 300 WBlower, Heated
Surface:
Locate a GFCI-protected 120 V, 15 A, grounded
duplex electrical outlet within 24" (610 mm) of the
Technical Information
bath junction box. A 40" (1016 mm) cable is
included.
All product dimensions are nominal.
FreestandingInstallation:
Locate the outlet behind the bath and within 24"
(610 mm) of the blower motor.
ReversibleDrain location:
45-1/8" x 19-11/16" (1147 mm x 500 mm)Basin area, bottom:
Remote blower installation kit K-1446 is available
for relocating the blower.
52-3/4" x 25-5/16" (1339 mm x 643 mm)Basin area, top:
100 lbs (45.4 kg)Weight:
NOTICE: Do not support the load weight of the
bath by the rim.
44.2 lbs/ft² (215.8 kg/m²)Minimum floor load:
15-1/16" (383 mm)Water depth:
NOTICE: Confirm adequate support for rim-mount
faucet. Using faucets as a means of support are
not appropriate or safe for this installation.
58 gal (219.6 L)Water capacity:
Blower: 120 V, 15 A, 60 Hz, 300 W
Heated Surface: 120 V, 0.5 A, 60 Hz
Electrical rating:
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
VariablePump speed:
3-speedPump speed:
USA/Canada: 1-800-4KOHLER (1-800-456-4537)
www.kohler.com
11-11-2014 01:56
ARCHER
®
62" FREESTANDING BUBBLEMASSAGE
™
BATH WITH BASK
™
HEATED SURFACE
K-2593-GW