Instructions / Assembly

Installation Guide SKU#27858,27860
USA/Canada: 1-800-4 KOHLER 1446229_8_A
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put
them onto a clean and soft cloth to protect finish. Confirm all
parts are included.
2. Loosen screws (G) and then remove mounting plate (B) from
canopy (F).
3. Attach mounting plate (B) onto outlet box with screws (D).
Ensure ground screw (C) is attached to mounting plate (B).
4. NOTICE: To avoid short circuit, make sure wires are not
exposed. Fasten fixture green or bare ground wire to the
green or bare copper wire in outlet box with wire nut (A) or
fasten onto ground screw (C) on mounting plate.
5. NOTICE: To avoid short circuit, make sure wires are not
exposed. Fasten fixture white wire to the white wire in outlet
box with wire nut (A). Wrap the wire connector with electrical
tape so that the tape seals the end of wire nut (A), see
diagram 1.
6. NOTICE: To avoid short circuit, make sure wires are not
exposed. Fasten the fixture black wire to the black wire in
outlet box with wire nut (A). Wrap the wire connector with
electrical tape so that the tape seals the end of wire nut (A),
see diagram 1.
7. Insert quick connector (E) into the opposing quick connector
end.
8. Tuck wires carefully inside outlet box. Attach the canopy (F)
onto mounting plate (B) with screws (G).
9. Thread light rod (K) onto the bottom of the fixture. Long rod
is for SKU#27858, short rod is for SKU#27860.
10. Install fabric shade (I) onto socket sleeve (H).
11. NOTICE: Do not exceed recommended wattage. Rated Max 60 W,
Type B. (Bulb(s) not included).
12. Put a bulb driver (J) over the bulb and screw it into socket.
Then take off bulb driver (J).
13. Repeat steps 10-12 for each fabric shade and bulb.
14. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY.
Clean glass with a mild soap.
Phillips &
Flathead Screwdriver
Wire
Cutter/stripper
Electrical Current
Teste r
Electrical
Tape
Approved fastener
(Wire nut)
Electrical ta
p
e
Diagram 1
Bulb driver