Installation Guide

2. Install the Hanger
6-1/2''
(165 mm)
With assistance, lift and place the cabinet in position against the nished wall.
Verify that the cabinet is level, then mark the top and centerline of the cabinet.
Carefully set the cabinet aside onto a padded surface.
Measure 6-1/2" (165 mm) down from the top, and draw a second mark.
Align the center of the hanger with the centerline, and the boom edge aligned with the lower mark.
Verify that the hanger is level.
NOTE: If installing hanger into wall studs, new 1/8" pilot holes aligned with the wall studs may need to be drilled into the
wall hanger. In addition, a 3/8" diameter, 1/4" deep counterbored hole will need to be added for the screwhead to sit ush.
Drill 1/8" holes into the wall through the pilot holes in the hanger.
Secure the hanger onto the wall with the wood screws (provided).
1384740-2-A
4 Kohler Co.