Installation Guide

4. Complete the Installation
Position the rear plate over the installation location.
Connect the rear plate to the wall using two screws.
Reconnect the cover plate cable to the base.
Snap the cover plate back into place.
Remove the screw and tape from the cover plate.
Secure the cover plate to the base with the screw.
NOTE: The remote control will not charge until the power cord has
been attached to the toilet. The remote control must charge for
approximately 30 minutes before it will be functional.
Position the remote control on the docking station. It attaches
magnetically.
After the toilet is installed, pair the remote control with the toilet
following the instructions in the toilet installation guide.
Reconnect.
Rear
Plate
1197249-2-A 10 Kohler Co.