Installation Guide

2. Mark the Installation Location
NOTE: The docking station comes with a 15’ (4.6 m) power cord.
Locate the docking station to allow the power cord to reach the
toilet.
Unpack the box containing the remote control components.
Remove the remote control from the docking station and set it
aside.
Remove the small screw on the bottom of the docking station.
Carefully remove the front plate by gently prying the sides of the
front plate out until they disconnect from the dock.
Carefully disconnect the cable.
Tape the screw to the front plate and set it aside.
NOTE: When the power cord is routed externally through the wall,
it may be easier to use the back cord opening. When the cord is
routed externally along the face of the wall, use the bottom cord
opening.
For installations using the back cord opening, route the power
cord through the back cord opening.
Holes
Screw
Back Cord
Opening
Disconnect.
Front Plate
Rear
Plate
Kohler Co. 7 1197249-2-A