Installation Guide

3. Connect the Power Cord
Loosen each of the five small screws located where the wires will
be connected.
Route the power cord into the docking station.
NOTE: There is a wiring schematic on the inside of the docking
station. Refer to the schematic when attaching the wires.
Slide the bare ends of the wires into the correct ports (as shown)
and tighten each screw to secure the wires in place.
Orange
Red
Blue
White
Black
Connector
Harness
Power Cord
Bottom Cord
Opening
Back Cord
Opening
Kohler Co. 9 1197249-2-A