Specification

Technical Information
Fixture:
Configuration Integral fill and
vertical spray*
Drain hole Ø 1-3/4″ (44 mm)
Spray hole Ø 3/4″ (19 mm)
Faucet hole Ø 3/8″ (35 mm)
Diverter hole Ø 5/16″ (33 mm)
Pop-up rod hole Ø 1-1/8″ (29 mm)
*Requires faucet with transfer valve or diverter.
Included components:
Floor screws and bolt caps 52049
Installation Notes
Install this product according to the installation guide.
Trap can be installed above or below the floor.
Hot and cold supplies can be installed from the floor or the
wall.
For floor supplies, hot and cold must be offset 1″ (25 mm)
away from the base (toward the wall).
24-3/8" (619 mm)
1-3/8" (35 mm)
14-5/8" (371 mm)
7-1/2" (191 mm)
1-1/4" OD
1-1/8" (29 mm)
Spray Hole
5-1/2" (140 mm)
Front of Bidet
*6" (152 mm) dimension required to allow for drain and
supply connection from rear of bidet.
*6"
(152 mm)
15-1/2" (394 mm)
7-1/2"
(191 mm)
2-3/4" (70 mm)
17-1/8"
(435 mm)
4-5/8"
(117 mm)
10-5/8" (270 mm)
6-1/2"
(165 mm)
4-5/8"
(117 mm)
Bottom of
Rear Access Opening
1" (25 mm)
Offset
Below
Floor
2"
(51 mm)
Above
Floor
9-13/16"
(249 mm)
Ø 1/2" (13 mm) Holes
Pop-Up
Rod Hole
Faucet
Hole
Diverter
Hole
15-1/2"
(394 mm)
2-5/8"
(67 mm)
Product Diagram
SAN TROPEZ
®
SAN TROPEZ
®
BIDET
Page2of2
113566-4-
AG