Installation Guide

Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
Observe all local plumbing and building codes.
Prior to installation, unpack the new sink and inspect it for
damage. Return the sink to its protective carton until you are
ready to install it.
This sink is not intended for undercounter installation.
Inspect the drain and supply tubing. Replace if necessary.
If possible, assemble the faucet and strainer to the sink before
installing the sink.
For a replacement installation, make sure the existing cut-out is
the same size or smaller than the cut-out for the new sink.
1. Preparation
Install the water supplies and drain piping according to the
roughing-in information.
Cut along the template line where indicated for the countertop
opening.
Pencil
Drill
Scissors
Putty Knife
Safety
Glasses
Tape
Measure
Keyhole/Compass
Saw
Sealant
Plus:
1/2" or larger drill bit
Rags or paper toweling
Template (supplied)
1019938-2-A 2 Kohler Co.