User Guide

2
1109784-A2-A
IMPORTANT INFORMATION
Due to the non-standard diameter of
the remote valve (51 mm), the remote
valve cannot be installed through a
standard 35 mm tap hole in a sink.
Choose a sink without tap holes
then install the tap and remote valve
through the countertop. Refer to the
countertop manufacturer for drilling
of the holes.
1. Make sure that you follow all
the local plumbing and building
regulations in operation.
2. For new installations, install the
tap in the sink before installing
the sink.
3. Before installation, unpack the
tap and inspect for damage.
Remote Valve
Tap
Plumbing Connections
G ½” Compression Fitting
Hot (H) and Cold (C) inlets must be connected to the correct inlet supplies.
Applicable Standards
ASME A112.18.1-2005/CSA B125.1-05; AS/NZS 6400:2005; AS/NZS 3718:2005;
AS/NZS 4020:2005
Recommended Operating Pressures: 140 to 860 kPa (20 to 125 psi).
Rated Operating Temperatures: 5° to 71° C (40° to 160° F).
Tested Hydrostatic Burst Pressure: 3450 kPa (500 psi).
SPECIFICATION