Specification Sheet

Installation Notes
Install this product according to the installation guide.
ADA compliant when installed to the specific requirement of
the regulation.
WARNING: Risk of property damage. For
exterior wall installations, ensure proper wall
insulation to prevent frozen pipes.
NOTICE: Do not locate the faucet in close proximity to a
direct heat source or use the faucet as a pot filler. Exposure
to excessive heat will damage the integral sprayhead and
spout joints and may cause severe discoloration to the carbon
fiber tubing.
Special framing and support considerations are required to
mount the wall-mount valve.
WARNING: Risk of property damage. Before
finishing the wall, ensure the supply lines are
connected to the mixer valve with the cold supply
line plumbed on the left and the hot supply line
plumbed on the right. Doing so will avoid replacing
the finished wall due to error.
One 2-3/16″ (56 mm) diameter cut-out hole is required for the
valve. One 1-3/16″ (30 mm) diameter cut-out hole is required
for the spout.
Will comply with CSA B651 when installed per Clause 4.3.6
of the standard.
2-1/16"
(52 mm)
4-5/16"
(110 mm)
Ø 2-5/8"
(67 mm)
Ø 2-5/8"
(67 mm)
4"
(102 mm)
6" (152 mm)
13-1/4" (337 mm) Max
COLD
Finished Wall
3-1/4"
(83 mm)
2-7/8"
(73 mm)
1-7/16"
(37 mm)
1-7/8"
(48 mm)
*
2-7/8"
(73 mm)
1-7/16"
(37 mm)
Ø 2-1/8" (54 mm)
4-1/8"
(105 mm)
4-1/8"
(105 mm)
11-1/16" (281 mm)
Ø 1-1/16"
(27 mm)
5/8"
(16 mm)
Thin Wall
Standard Wall
Thick Wall
*
0"- 5/8" (16 mm)
1/2" (13 mm) - 1-1/8" (29 mm)
1" (25 mm) - 1-5/8" (41 mm)
Finished Wall Thickness
Product Diagram
KARBON
®
KARBON
®
WALL-MOUNT KITCHEN SINK FAUCET
Page2of2
1095311-4-
H