Installation Guide

1. Install the Framing

IMPORTANT! This installation requires 2x6 studs. Note the

center-to-center stud dimension is not standard.

IMPORTANT! Note the 4″ (102 mm) dimension from the front edge

of the framing to the center of the outlet pipe. This dimension is

critical for the installation.

NOTE: Refer to the speciﬁcation sheet for more details and

dimensions for roughing-in.

NOTE: The waste outlet pipe may need to be relocated for this

installation.

NOTE: A plastic elbow is supplied with this product. A cast iron

elbow may be required by codes in some areas. The height of the

toilet drain pipe may need to be adjusted if the cast iron elbow is

used.

Construct the stud pocket using lag bolts.

Install the stud pocket following the dimension shown.

19"

(483 mm)

19"

(483 mm)

Waste

Outlet

Pipe

4" (102 mm)

9-1/2" (483 mm)

2x6 Studs

19"

(483 mm)

4" (102 mm)

Ø 3-9/16"

(90 mm)

1142998-2-B 4 Kohler Co.