Installation Guide

4. Connect the Spray Hose
Slide the weight onto the spray hose.
Verify that the hose ends are clean and that the O-ring is in place.
Fully engage the hose ends.
Extend and retract the spray hose to check for smooth operation.
Reposition the supply hoses if necessary.
Check all connections for leaks.
Verify the spray head is completely seated into the spout. If the
spray head is not seated properly, follow the ″Reposition the
Weight″ procedure below.
Reposition the Weight
Position the weight between 2″ (5.1 cm) and 3″ (7.6 cm) from the
cabinet floor.
Secure a cable tie (not provided) around the spray hose and
below the weight, as shown. Do not overtighten the cable tie
around the spray hose.
Cut the free end of the cable tie. Be careful not to damage the
spray hose.
Extend the spray hose to ensure the spray hose does not snag or
catch on items in the cabinet.
Retract the spray hose and verify that the spray head is properly
seated into the spout.
Weight
Spray Hose
O-Ring
2" (5.1 cm) –
3" (7.6 cm)
Connect the Spray Hose
Valve Outlet Hose
Cabinet
Floor
Reposition the Weight
(If Applicable)
Do not
overtighten
cable tie.
Kohler Co. 5 1071380-2-A