Installation Guide

ManualsBrandsKOHLER ManualsKitchenAvatar Single Control Pull-Out Kitchen Sink Faucet in Polished Chrome

Installation Guide

Single-Control Kitchen Sink Faucets

M product numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

M corresponden a México (Ej.

K-12345M)

Français, page“ Français-1”

Español, página“ Español-1”

K-6352 K-6353

1025494-2-B

Summary of content (8 pages)

PAGE 1
Installation Guide Single-Control Kitchen Sink Faucets K-6352 M product numbers are for Mexico (i.e. K-12345M) Los números de productos seguidos de M corresponden a México (Ej.
PAGE 2
Tools and Materials Assorted Screwdrivers Adjustable Wrench Plumbers Putty Pipe Wrench Strap Wrench 5/64" Hex Wrench Thread Sealant Socket Wrench with 7/16" Deep Socket Tube Cutter Pliers Thank You For Choosing Kohler Company We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don’t hesitate to contact us.
PAGE 3
Faucet Body Hose Rubber Washer Escutcheon Spacer O-Ring 1. Install the Mounting Stud Disconnect the hose from the hose connector. Screw the mounting stud into the threaded hole at the bottom of the faucet body. The mounting stud should extend slightly beyond the threaded hole in the body. 1. Install the Escutcheon (Optional) NOTE: For installation on marble, do not use plumbers putty. Use the self-adhesive gaskets provided.
PAGE 4
Hose Connector Bracket Washer Nut Weight Screw Hose Weight 3" (7.6 cm) or Larger Cold Hot 23" (58.4 cm) 1. Faucet Installation From the underside of the sink, position the bracket, washer and nut onto the mounting stud. Position the faucet and escutcheon on the sink to obtain the desired alignment. Tighten the nut securing the faucet to the sink. For best access, use a socket wrench with a 7/16” deep socket.
PAGE 5
Install the Supplies (cont.) Install the sink using the sink manufacturer’s instructions. Connect the supply hoses to the supply stops. Tighten all connections. Kohler Co.
PAGE 6
3. Installation Checkout Ensure that all coupling nuts are tight. Ensure that the lever handle is in the down position. Open the drain. Remove the sprayhead and screen from the end of the hose. Position the hose in the sink. Turn on the main water supply and open the valve for one minute to flush the fitting. Reattach the spray and screen. Turn on the water and check for leaks. Adjust as needed. 1025494-2-B 6 Kohler Co.
PAGE 7
Handle Setscrew Bonnet Stop Tab Valve Stem Top Disc Mounting Nut Indexer Splines 4. Water Temperature Adjustments NOTE: Prior to adjustment, make sure the handle is in the maximum hot position. Remove the setscrew, handle, and bonnet. Turn on the water to the maximum temperature by pushing the valve stem up and turning it clockwise. Mark the current position of the temperature stop tab (top edge) on the mounting nut with a marker or pencil.