Installation Sheet

3. Mounting the Water Filtration System
CAUTION: Risk of property damage. Do not install the unit
where the temperature may drop below freezing, may be
exposed to direct sunlight, or may be exposed to heat.
CAUTION: Risk of personal injury or property damage. Use
caution when installing near water pipes or electrical lines.
IMPORTANT! The unit must be mounted vertically.
IMPORTANT! The mounting location of the water filtration system
is critical. Verify the following before mounting: the bottom of the
filter cartridge will be at least 2″ (5.1 cm) from the floor of the
cabinet, the system will not interfere with other items under the
counter, and the hoses will not be under tension when installed to
the ports on the filter head.
Align the mounting holes of the mounting bracket at the
determined location.
Mark the mounting hole locations with a pencil. Set the unit
aside.
Pre-drill the holes, if necessary.
Partially thread the screws into the cabinet wall and slide the
mounting bracket over the screws.
Secure the screws into the cabinet wall.
Mounting
Bracket
Screws
(Not Supplied)
1015061-2-G 6 Kohler Co.