Installation Guide

8. Prepare the Site

NOTE: Vertical wall installation shown. The valve can also be wall-mounted horizontally or mounted to a

horizontal surface. Refer to the ″Valve Mounting Conﬁgurations″ section.

This product is designed to ﬁt within a minimum 21″ (53.3 cm) 2x4 stud cavity. If necessary to

modify the stud cavity, apply adequate bracing for mounting the valve.

9. Install the Electrical Outlet

CAUTION: Risk of product damage. The power supply is rated to operate in temperatures up to

104°F (40°C). Do not install the power supply under a whirlpool surround or in any location where the

temperature may reach temperatures over 104°F (40°C).

Install a 120 V GFCI electrical outlet, within the stud framing, in close proximity to the valve. Locate

the outlet above the valve allowing ample space to mount the power supply in close proximity to

the outlet.

1-1/4" (3.2 cm)

20-3/16"

(51.3 cm)

Screws

Valve

Power Supply

Outlet

Drip Loop

Place outlet and

power supply higher

than electronic valve.

Install bracing.

6" (15.2 cm)

21" (53.3 cm) Min

Kohler Co. 13 1043183-2-B