Installation Guide

9. Install the Glass Shelf

Insert a bearing into the mounted post. Align the holes in the

bearing with the hex slots on the post.

Slide the center cap over the mounted post. Align the holes in the

center cap with the hex slots in the post.

Slide a support bar through the bearing.

Place a sleeve over the bracket extension on a shelf bracket.

Screw the shelf bracket onto the support bar.

Place a sleeve over the opposite end of the support bar.

Screw a knob and washer onto the support bar.

Repeat this procedure for the remaining mounted post.

Start the setscrews into the shelf brackets. Make sure the

setscrews do not protrude into the inside of the shelf bracket.

Wet the end of the glass shelf with a mild soap solution.

Carefully slide the shelf into the brackets.

Adjust the shelf brackets as necessary to achieve level.

Tighten all setscrews.

Knob

Support Bar

Mounting Screw

Bearing

Center Cap

Bracket

Extension

Shelf Bracket

Sleeve

Washer

Post

Kohler Co. 13 1020822-2-B