Installation Guide

1. Prepare the Site
IMPORTANT! Secure the piping to the framing.
Install or relocate the water supplies as necessary.
A typical bath and shower installation is plumbed using 1/2″
copper tubing and adapters.
Use thread sealant on all threaded connections.
Temporarily install 1/2″ nipples to the bath and shower elbows,
extending at least 2″ (5.1 cm) beyond the finished wall.
For spout-only installation, plug the unused shower outlet on the
yoke or valve.
Turn on the water supply and check for leaks.
Complete the finished wall.
Shower
Outlet
Shower
Outlet
1/2" Tubing
1/2" Piping
Bath Ell
Temporary
Nipple
Temporary
Nipple
1/2" Male
Adapters
Bath Ell
1/2" Male
Adapters
Kohler Co. 3 1011147-2-C