Installation Guide

2. Install the Adjustment Clamps
Insert four adjustment clamps into each wall jamb (eight total).
Partially thread a #8-18 x 3/4″ flathead screw through each pre-drilled hole in the wall jambs and
into an adjustment clamp using the 3/32″ hex wrench provided. Do not fully tighten the screws at
this time to allow strike jamb and hinge jamb installation.
Adjustment Clamp
Top View
Flathead Screw
Wall Jamb
#8-18 x 3/4"
Do not fully tighten screw.
Wall Jamb
Top View
Wall Jamb
Adjustment Clamp
Note:
Kohler Co. 5 1036565-2-D