Installation Guide

9. Adjust and Secure the Door
The glass on the door should be aligned evenly with the back edge of the bulb seal. The edge of the
glass should be 3/16 (5 mm) from the strike jamb.
If the door needs adjusting, loosen the screws holding the hinge jamb in place (do not remove) and
shift the assembly as needed. Adjust the strike jamb in the same manner. The door may be adjusted
3/4 (1.9 cm) on each side.
When each side of the door is uniformly aligned, fully tighten the screws.
Kohler Co. 13 1036565-2-D