Installation Guide

10. Install the End Caps
Install the end caps to the top of the wall jambs. Flat edges should be toward the wall.
11. Install the Handles
Thread the setscrew into the handle with the logo.
Slide a spacer over the setscrew.
Slide the handle assembly through the hole in the glass door, making sure the logo is facing the
outside of the shower. Do not fully tighten.
Slide the second spacer over the other end of the setscrew. Thread the second handle onto the
setscrew.
Fully tighten both of the handles evenly, making sure the logo is properly oriented.
Etched
Logo
Outside
Handle
Inside
Handle
Handle
Setscrew
Spacer
Hole in
glass
Spacer
Wall Jamb
End Cap
Bottom View
End Cap
1036565-2-B 12 Kohler Co.