Installation Guide

1. Determine the Door Configuration
IMPORTANT! Separate assembly instructions may apply depending on which pivot configuration is
chosen. For purposes of these instructions, a ″left hinge″ installation is shown.
IMPORTANT! Install the pivot side of the door on the side opposite the showerhead for easy access to
shower controls.
Determine whether the door will pivot on the right or left side.
Make sure the door can swing freely in the chosen configuration.
2. Install the Adjustment Clamps
Insert four adjustment clamps into each wall jamb (eight total).
Partially thread a #8-18 x 3/4″ flathead screw through each pre-drilled hole in the wall jambs and
into an adjustment clamp using the 3/32″ hex wrench provided. Do not fully tighten the screws at
this time to allow strike jamb and hinge jamb installation.
#8-18 x 3/4" Screw
Do not fully
tighten screw.
Wall Jamb
Top View
Wall Jamb
Adjustment Clamp
Adjustment
Clamp
Top View
Flathead Screw
Wall Jamb
Note:
1036565-2-B 4 Kohler Co.