Installation Guide

2. Measure and Cut the Bottom Track
CAUTION: Risk of personal injury. Always wear safety glasses while cutting.
NOTE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
Measure from wall to wall at the bottom of the shower door opening. This is distance ″D″.
Subtract 1/16″ (2 mm) from distance ″D.″ The resulting dimension is the bottom track cut length.
Mark the bottom track at the determined distance.
NOTE: For best results use a miter box and 32-tooth per inch hacksaw to make the cut.
Cut the bottom track at the mark.
File the rough edges smooth where the bottom track was cut, taking care to avoid damaging
finished surfaces.
The cut bottom track should sit flush on the threshold without hand pressure or tape to hold it
down.
D
Angled
Base
Curved
Base
Measure carefully. If your walls
are curved or angled, measure above the curve or
angle. Failure to do so can result in an improperly cut
bottom track and can void the warranty.
Measure distance
"D" above curves in
the corners.
Measure
here.
Measure
here.
Warning:
Kohler Co. 7 1064866-2-B