Installation Guide

20. Complete the Installation
Attach the Bumpers and Kohler Logo
Install one bumper on the edge of the side panel frame as shown.
Install two bumpers on the filler in the transom.
If applicable, install the KOHLER logo on the center of the threshold (not shown).
Apply Sealant
IMPORTANT! Carefully follow the silicone sealant manufacturer’s instructions for application and curing
time.
NOTE: Thoroughly clean and dry all surfaces where silicone sealant will be applied.
Use masking tape to protect areas adjacent to those where the sealant is being applied.
Apply a bead of silicone sealant to the outside and inside of the vertical joints where wall jambs
meet the wall.
Apply a bead of sealant to the outside of the vertical joint between the wall jamb and side panel as
shown.
Apply a bead of silicone sealant to the dry side of the threshold where it meets the shower ledge.
Do not apply sealant to the wet side of the threshold.
Apply a bead of sealant where the header expander meets the ceiling to create a steam barrier.
Troubleshooting
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4-KOHLER.
Troubleshooting Table
Symptoms Recommended Action
Water Leaks
1. Water leaks under the side panel. A. From the outside the shower, apply silicone to the joint
where the side panel meets the threshold.
Seal here
(outside only).
Seal here.
Seal here
(inside and
outside).
Seal here
(inside and
outside).
Bumper
Side Panel
Frame
1144163-2-B 24 Kohler Co.