Installation Guide

1. Determine the Door Configuration
IMPORTANT! Depending on which pivot configuration is chosen (left or right) your assembly
instructions will vary. For purposes of these instructions, a ″left hinge″ installation is shown.
Determine whether the door will pivot on the right or left side.
NOTE: The door will hinge on the same side as the side panel.
Make sure the door can swing freely in the chosen configuration.
The height of your installation opening ″A″ must be between 89″ (226.1 cm) and 89-1/2″ (227.3
cm).
2. Measure and Cut the Wall Jambs
CAUTION: Risk of personal injury. Always wear safety glasses while cutting.
IMPORTANT! The wall jambs must sit flush against the sidewalls and shower ledge. If your shower has
curved corners where the sidewalls meet the ledge, it may be necessary to shape the bottom ends of the
wall jambs with a file.
NOTE: A label marks the top of each wall jamb. Do not remove the labels until the wall jambs are
installed.
Carefully measure the height ″A″ of the finished opening. Refer to the roughing-in sheet to confirm
that the door will fit in the finished opening.
Cut the wall jambs to this measurement. Make sure to cut the end labeled ″Cut this end″. For best
results, use a 32-teeth per inch hacksaw blade and a miter box.
Cut the end
with the "Cut
this end" label.
Right Wall Jamb
Left Wall
Jamb
A = Height
Kohler Co. 5 1144163-2-B