Installation Guide

17. Install the Outside Transom Panel
Remove the filler above the side panel.
Identify the top of the outside transom panel - the two metal side frames are flush with the plastic
frame.
From inside the shower, lift and tilt the outside transom panel up into the outside track of the top
track.
Tilt the bottom of the panel towards the header until it sits in the track on the top of the header.
Slide the panel towards the wall jamb and align the side frame with the frame on the side panel.
Reinstall the filler between the wall jamb and the panel with the bulb seal toward the panel.
Using the pre-drilled holes in the wall jamb, drill 1/8″ holes into the filler.
Using a 3/32″ hex wrench, secure the filler to the wall jamb with two #8 x 3/4″ flathead screws.
Press the pile seal into the channel on the inside of the transom panel frame.
Filler
Outside
Transom Panel
Top Track
Header
Outside
Track
Pile Seal
Kohler Co. 21 1144163-2-B