Installation Guide

21. Assemble the Outside Panel
NOTICE: The outside panel roller mounting holes are 3-1/8″ (79 mm) below the top of the panel.
Position the roller on the opposite side of the panel as the label.
Install the outside rollers with the tab on the clamp on top.
Secure each roller with a #10-24 x 1-1/4” screw.
Hold the clip downwards as the screw is tightened.
Using a hand screwdriver only, tighten the screws securely until the clip cannot be rotated by
hand.
x2
#10-24 x 1-1/4"
3-1/8"
(79 mm)
Clip
Down
Tab Up
Clip Assembly
Clamp
Outside Roller
1314827-2-A 24 Kohler Co.