Installation Guide

14. Secure the Inside Header to the Bracket
IMPORTANT! The inside header is secured to the brackets in this step so that the door panel may be
hung.
Press the header against the bracket, and slide the header connectors all the way to the wall at each
end of the header.
NOTE: If the header connector does not slide over the bracket, either the screw must be loosened, the
header is not properly installed on the bracket, or the bracket is tilted away from the wall. Make any
adjustments as necessary.
Secure the header by tightening each header connector screw with a 1/8 hex wrench.
1/8"
Press against
the bracket.
Kohler Co. 17 1380408-2-B