Installation Guide

Troubleshooting (cont.)
Troubleshooting Table
Symptoms Probable Cause Recommended Action
B. The centerguide clip is not
installed.
B. Remove the outside header and
both door panels. Install the clip,
then install the centerguide over
the clip. Reinstall the panels and
outside header.
C. The screw connecting the
centerguide clip is loose.
C. Remove the outside header and
both door panels. Tighten the clip
screw. If the screw does not
tighten, drill a new hole close to
the original hole. Install the
centerguide over the clip. Reinstall
the panels and outside header.
D. The film on the adhesive on the
bottom of the centerguide was
not removed.
D. Remove the outside header and
both door panels. Lift the
centerguide off the clip, remove the
film on the tape and reinstall the
centerguide over the clip. Reinstall
the panels and outside header.
5. Water leaks. A. Water leaks under the threshold. A. Apply 100% silicone sealant to the
outside edge of the threshold. See
the sealant manufacturer’s
instructions before using the
shower.
B. Water leaks under a door panel. B. Adjust the rollers to lower the door
panels closer to the shower ledge.
Refer to the ″Adjust the Door
Panels″ section.
C. Water leaks under a door panel. C. Check the height of the header. The
header should sit on top of the
wall jambs.
D. Water leaks between the door
panels.
D. When showering, make sure the
inside panel is closest to the
showerhead.
E. Water leaks around the wall
jamb.
E. Adjust the door panel so the panel
touches both the top and bottom
bumpers. Try not to spray water
directly onto the door panels.
F. Water leaks at the bottom of the
wall jamb and over the
threshold.
F. If there is a gap between the
bottom of the wall jamb seal and
the top of the threshold, silicone
this area.
6. The wall jamb cannot be
installed under the
header.
A. The bracket is installed too low. A. Adjust the bracket higher by
loosening the screws and pushing
upward on the bracket.
1380408-2-B 30 Kohler Co.