Rough-In Guide

Product Information
Applicable product:
5.5’ (1.7 m) BubbleMassage bath K-712-G
Fixture*:
Bathing well:
Basin area,
bottom
47-1/2″ (120.7 cm) x 25″ (63.5 cm)
Basin area, top 55″ (139.7 cm) x 29″ (73.7 cm)
Weight 500 lbs (227 kg)
To overflow:
Water depth 12-5/8″ (32.1 cm)
Capacity 64 gal (242.3 L)
* Approximate measurements for comparison only.
Included component:
Cut-out template 88051-7
Blower
motor:
Heater V Hz A
300 W 220-240 50/60 3
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are
relocated, two access panels are required. Locate one
access panel at the blower motor/control location and the
other at the control box. Locate the blower motor and check
valve together.
Floor support under bath must provide for a minimum of 65
lbs/square foot (314 kg/square meter) loading.
Splitting the deck/surround is recommended if installing into a
deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ASME Standard A112.19.1/CSA B45.2. All
dimensions are nominal.
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
No change in measurements if connected with
drain illustrated. (K-7103)
66" (167.6 cm)
36" (91.4 cm)
2-11/16"
(6.8 cm)
9-11/16"
(24.6 cm)
18"
(45.7 cm)
2-7/8"
(7.3 cm)
3" (7.6 cm)
1-1/2" OD
4"
(10.2 cm)
1"
(2.5 cm)
19-1/4"
(48.9 cm)
1/2"
(1.3 cm)
NOTE: Blower protrusion beyond the rim.
1" (2.5 cm)
Roughing-In
K-712-G
IRON WORKS
®
5.5’ (1.7 m) BUBBLEMASSAGETM BATH
IRON WORKS
®
5.5’ (1.7 m) BUBBLEMASSAGETM BATH
1146827-1-
A