Installation Guide

112035-2-AA (A)

Kohler Co., Kohler, WI

Assemble nut and gasket on drain ell, and nut, washer

and cone washer on tube. Align parts with tee as shown.

Insert tubes completely into tee. Align and tighten the

nuts.

Attach tailpiece to tee and tighten, Tailpiece may need to

be cut for proper fit. 1” to 2” of tailpiece should fit inside the

trap. Install bath according to manufacturer’s installation

instructions. Make sure the tailpiece on the drain fits

properly into the trap.

Fig. #6

Tube

Nuts

Drain Ell

Tee

Gasket

Cone

Washer

FOR ABOVE FLOOR INSTALLATIONS: Assemble as

shown, following preceding instructions.

Fig. #7

Tube

Nuts

Drain Ell

Tee

Gasket

Cone

Washer

If necessary, loosen the screw and adjust linkage to the

proper bath size. The screw should be lined up on the 16

for the 16” bath, 14 for the 14” bath, etc. Refer to the bath

installation instructions to determine your bath size.

Tighten screw after adjusting.

Fig. #8

Insert lift rod assembly into overflow ell. Tighten overflow

hood to overflow ell with the two screws provided.

Fig. #9

Assemble handle to overflow hood with phillips screw

provided. It may be necessary to adjust handle to a

desired position.

Fig. #10

Handle

Overflow

Hood