Rough-In Guide

Product Information
Applicable products:
5’ bath whirlpool – left drain K-723-H2
5’ bath whirlpool – right drain K-724-H2
ADA compliant when installed per Section
607 of the Act.
Fixture*:
Bathing well:
Basin area, bottom 45” (114.3 cm) x 23” (58.4 cm)
Basin area, top 54” (137.2 cm) x 25” (63.5 cm)
Weight 390 lbs (176.9 kg)
To overflow:
Water depth 11-5/8” (29.5 cm)
Capacity 52 gal (196.8 L)
* Approximate measurements for comparison only.
Pump kW V A*
1.5 240 11
* Approximate measurements for comparison only.
Minimum access panel (required):
Pump/control 30″ (76.2 cm) W x 15″ (38.1 cm) H
Required accessories:
Jet trim kit K-9696
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
NOTE: Pump protrusion beyond rim.
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
61 lbs/square foot (295 kg/square meter) loading.
Fixtures conforms to ASME Standard A112.19.1. All
dimensions are nominal.
Note: Pump Protrudes Beyond Rim
1" (2.5 cm)
16"
(40.6 cm)
32"
(81.3 cm)
3-1/4"
(8.3 cm)
1-1/2"
(3.8 cm)
Pump/Control Access
33-3/4" (85.7 cm)
1/8" (3 mm)
1-1/2" OD
1-13/16" (4.6 cm)
8-1/2" (21.6 cm)
60" (152.4 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
17-7/16"
(44.3 cm)
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
Roughing-In
K-723-H2, K-724-H2
MEMOIRS
®
5’ BATH WHIRLPOOL
MEMOIRS
®
5’ BATH WHIRLPOOL
1019707-1-
D