Instructions / Assembly
Installation Guide
SKU#72582/72584
USA/Canada: 1-800-4 KOHLER 1473943-2_A
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damage. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1.
Remove the fixture and parts bag(s) from the carton. Put them onto a
clean and soft cloth to protect finish. Confirm all parts are included.
2. Loosen knurled nuts (G) and then remove mounting plate (B) from
canopy (F).
3. Attach mounting plate (B) onto outlet box with screws (D). Ensure
ground screw (C) is attached to mounting plate (B).
4. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in
outlet box with wire nut (A) or fasten onto ground screw (C) on mounting
plate.
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wire to the white wire in outlet box with wire nut (A). Wrap
the wire connector with electrical tape so that the tape seals the end of
wire nut (A), see diagram 1.
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
the fixture black wire to the black wire in outlet box with wire nut (A).
Wrap the wire connector with electrical tape so that the tape seals the
end of wire nut (A), see diagram 1.
7. Insert quick connector (E) into the opposing quick connector end.
8. Tuck wires carefully inside outlet box. Attach the canopy (F) onto
mounting plate (B) with knurled nuts (G).
9. NOTICE: Do not exceed recommended wattage.
Rated Max 40 W,
Type B. (Bulb(s) not included).
10. Install bulb to the socket (I).
11. Remove screws (H), place inner glass (J) over the bulb and then install
outer glass (K) over the inner glass (J) with screws (H). NOTICE:
Tightening the screws (H) too tight will cause the glass crack.
12. Repeat steps 9-11 until all shades are installed.
13. Restore power to circuit at breaker or fuse box.
CLEANING: Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
Phillips &
Flathead Screwdriver
Wire
Cutter/stripper
Electrical Current
Test er
Electrical
Tape
Approved fastener
(Wire nut)
Electrical tape
Diagram 1