Installation Guide

ManualsBrandsKohler ManualsBathroom FaucetsKohler Triton Widespread Bathroom Faucet with Ultra-Glide Valve Technology - Without Drain Assembly or Handles

113614–2–AA(9550)



GOOSENECK SPOUT KIT

BEFORE YOU BEGIN

HOW TO USE THESE INSTRUCTIONS

These instructions contain important installation informa-

tion. Please leave instructions for the consumer.

NOTE: This spout kit provides the instructions for either

flexible hose or rigid supply connection. Perform the pro-

cedures applicable to your installation.

ROUGHING-IN DIMENSIONS

Fig. #1

FLEXIBLE HOSE TEE

CONNECTION

RIGID SUPPLY

CONNECTION

73952

2-7/8”

TYPICAL

2” D.

9/16” D.

7-15/16”

5”

1”

9/16”

5”

73953

12-5/16”

FLEXIBLE HOSE TEE

CONNECTION ONLY

1/8”-18 NPSM

1/2”-14 NPSM

* MAX. DECK THICKNESS

1-7/16” FOR RIGID SUPPLY

2” FOR HOSE CONNECTION

2-7/8”

TYPICAL

7-15/16”

*MAX

DECK

THICKNESS

Summary of content (4 pages)

PAGE 1
GOOSENECK SPOUT KIT BEFORE YOU BEGIN HOW TO USE THESE INSTRUCTIONS These instructions contain important installation information. Please leave instructions for the consumer. NOTE: This spout kit provides the instructions for either flexible hose or rigid supply connection. Perform the procedures applicable to your installation. ROUGHING-IN DIMENSIONS 73952 73953 5” 12-5/16” 2” D. *MAX DECK THICKNESS 7-15/16” 9/16” D.
PAGE 2
INSTALLATION INSTALL SPOUT Thread escutcheon onto spout. Place gasket onto spout and insert spout shank through top of fixture. For spout with lift rod, ensure lift rod faces back of fixture. Spout Lift Rod Slide special washer onto shank from underneath fixture with lift rod hole facing toward the rear. Secure with nut. Escutcheon Gasket Special Washer Fig. #2 Nut INSTALL TEE (FOR FLEXIBLE HOSE CONNECTION) NOTE: Lubricate O-rings and sleeve with a non-petroleum based lubricant to aid in assembly.
PAGE 3
NOTE: Lubricate O-rings and sleeve with a non-petroleum based lubricant to aid in assembly. Place plastic gasket and rubber washer into threaded opening at top of rigid supply sleeve. Slide washer onto spout shank. With UP arrow (↑) on rigid supply pointing upward, thread sleeve in rigid supply onto spout shank. Spout Shank Washer Rubber Washer Plastic Gasket Tighten sleeve hex-end. Rigid Supply Sleeve Sleeve Hex-End Rigid Supply Fig. #5 Slide washer down shank to sleeve.
PAGE 4
SERVICE PARTS 1 2 2 3 19 22 20 3 4 21 4 5 6 11 7 12 8 13 8 10 15 14 6 7 8 9 9 16 17 9 5 14 15 10 18 SERVICE PARTS SERVICE KITS ITEM PART NO.