Installation guide

3
116570-2-
AA (B)
Kohler Co., Kohler, WI
DRAIN (OTHER FINISHES)
 Remove the flange from the body.
 Thread the nut completely onto the body.
 Apply a 1/2” diameter ring of plumbers putty or
other sealant to the underside of the drain flange
according to the putty manufacturer’s instructions.
 Insert the drain body up into the underside of the
lavatory drain hole.
 Position the body so the seal hole is facing toward
the back of the lavatory.
 Thread the flange onto the drain body from the
topside of the lavatory.
 Securely handtighten the nut from the underside of
the lavatory.
 Remove any excess putty or sealant.
Seal
Hole
Apply Plumbers
Putty
Body
Nut
Lavatory
Underside
Flange
 Assemble the nylon washer, metal washer, and
nut onto the long end of the rod.
 Assemble the nylon washer and rubber washer
onto the short end of the rod.
Rod
Nut
Nylon Washer
Nylon Washer
Metal Washer
Rubber Washer
ALL DRAINS
 Insert the stopper into the flange.
 Remove the body nut from the seal hole.
 Fit the short end of the rod into the body seal hole
and under the stopper for regular installations;
through the hole for vandal-resistant installations.
 Loosely secure in place with the body nut.
 Remove and adjust the stopper so the stopper lifts
about 3/8” when opened. To adjust, loosen the
stopper nut and shorten or lengthen the stopper as
needed. Re-tighten the stopper nut.
 Handtighten the body nut.
 Apply thread sealant to the tailpiece. Thread the
tailpiece into the body and securely handtighten.
Stopper
Rod
Seal Hole
Body
Nut
Apply Thread
Sealant
Tailpiece
Stopper
Nut
Body
 Slide the clip and the link onto the rod with the
thumb screw facing toward the back of the
lavatory.
 To move the link to the proper position, squeeze
the clip and slide it along the rod.
 Push the rod down (open position).
Thumb Screw
Link
Clip
Rod