Installation guide

116570-2-AA (B)
4
Kohler Co., Kohler, WI
 Slide the faucet lift rod through the hole in the
spout and through the hole in the link.
 Tighten the thumb screw on the link so the lift
rod knob is 1/2” above the lift rod hole.
1/2”
Lift Rod
IF THE LAVATORY IS NOT INSTALLED, INSTALL IT AT THIS TIME. BE SURE TO
FOLLOW ALL INSTRUCTIONS PACKED WITH THE LAVATORY.
SUPPLIES AND STOPS
 Connect the supply tubes to the faucet end
bodies and supply stops. (Left is hot – right is
cold.)
 Tighten all connections.
HOT
COLD
Union
Compression
Nut
INSTALLATION CHECKOUT
 Connect the tailpiece and P-trap.
 Ensure that all connections are tight.
 Remove the aerator.
 Open the drain.
 Turn on the main water supply and check for
Spout
Turn
on
the
main
water
su ly
and
check
for
leaks.
 Open both hot and cold valves and run water
through the spout to remove any debris. Turn the
valves off.
 Reinstall the aerator.
Aerator
CALL US FOR HELP – 1-800-4-KOHLER
REQUESTING SERVICE
Here’s what you need to do if you require service:
First review the installation instructions to ensure correct installation. If you are still unable to correct
the problem, call our Customer Service Department for direct help. Dial
1-800-4-KOHLER.